Control and housing interface

recessed linear lighting compatibility checks

Before approving recessed linear lighting, review a representative joint and visible finish together. Confirm the proposed dimming combination independently of the visual finish approval. Keep the approved module schedule tied to the quotation revision, including any proposed substitutions. Tie the acceptance record to the proposed recessed linear lighting model and quotation revision. This page is a procurement checklist, not a wiring tutorial.

Control-chain checks

Supply → Driver or ballast → Fixture → Control interface

Known equipment: Record identifiers from the existing ceiling grid, remote driver location, and the wall or rack control (phase-cut, 0-10V dimming, DALI or a proprietary gateway). Photograph labels if model text is worn, but do not treat a photo as a run drawing. Note output direction and diffuser type on the same record.
Requested change: State whether the housing is a new recessed linear extrusion, a retrofit into an existing slot, or a suspended sibling offered as an alternative. Nominal slot width alone does not prove the flange will sit flush. Ask for ballast compatibility notes only when a fluorescent trough remains in circuit; Type A, Type B and Type C tube rules do not transfer to architectural linear housings.
Unconfirmed interface: Ask the supplier for compatibility evidence for that model against the recorded control. Constant current remote drivers and constant voltage decorative modules are not interchangeable by wattage; match rated output current in mA to the housing. 0-10V dimming, DALI and phase-cut are different interfaces; a photo of a wall plate is not a dimming protocol. Unresolved supply dimming and connection scope stay on the open-question list until a quotation revision names them. Recessed indoor slots are not wet location ratings.

Model documents or sample observations should address output direction, diffuser, joint appearance and whether through-wiring kits are included. Visual finish approval is a separate decision from dimming interface acceptance. A fluorescent trough that remains in circuit raises a ballast-compatibility question; that is not the same purchasing path as a new recessed linear extrusion with a dedicated driver. Architectural Linear Lights Sourcing records those two decisions; we do not commission scenes, publish a bypass wiring method or issue electrical permits. Continue with inquiry options, manufacturer matching or the RFQ form. The run-assembly article restates how to keep recessed linear lighting on its own line.

recessed linear lighting compatibility checks

Control-chain checks

Keep the recessed interface on the next quote revision